November 30th, 2017 - 2017 Parts Wrap-Up for Project Mugen PRO.2
Some of the odds and ends I picked up throughout the year.
 |
| Honda imitation JDM License Plate Seal |
 |
| Replacement EF8 / SiR fuel and temp gauges, in case the sending unit isn't my problem. |
 |
| A Tilt License Plate bracket (Came with the dual plate frames below) |
 |
| Spending all this money and time in a light-up JDM license plate I thought I should protect it |
 |
| Spending all this money and time in a light-up JDM license plate I thought I should protect it with a plate cover and frame |
 |
| Imitation JDM License Plate -- CR-X!!! |
 |
| The Asian SE of the OttoMobile 1:18 Scale CR-X. |
 |
| The Asian SE of the OttoMobile 1:18 Scale CR-X. |
|
 |
| The Asian SE of the OttoMobile 1:18 Scale CR-X. |
 |
| Red Japan Auto Federation (JAF) Front Bumper Emblem |
 |
| Left: Genuine Mugen Spoiler Bracket -- Right: Replica Bracket |
 |
| Spoon Brake Cylinder Sock |
 |
| Spoon Wiper "Brades". Stock size is 500mm, the EK9 was the closest at 500mm/450mm. |
 |
| Spoon Wiper Blades |
 |
| Spoon Wiper Blades |
 |
| Spoon Wiper Blades |
 |
| Spoon Wiper Blades |
 |
| Since I cannot use a rear strut bar until I further modify mine, I capped the hole with the stock covers. |
 |
| Some new center vents. I will try modifying these for some LEDs for an alarm. |
Remember, this blog was written in chronological order so, you will need to click OLDER POSTS to move forward in time, and click NEWER POSTS to go backwards.
No comments:
Post a Comment